estwera.blogg.se - How do i format my usb drive to fat32 from windows 10

Open the main menu, move your cursor over "Accessories" and then click on "Terminal." At the terminal prompt, type sudo apt-get install gparted and press Enter.

Plug your flash drive into an empty USB port and back up any data on the drive.

Please replace /dev/sdb1 with your corresponding device. Issue the command below to format the new volume: sudo mkfs.vfat /dev/sdb1 Once again pay attention to this name as there will not be any protection to prevent you to erase an other disk.

See your new partition label with the command lsblk.

Then press letter w to write table to disk and exit. Making a primary partition when prompted, if you are not sure. You will be prompted for the size of the partition.

Then press letter o to create a new empty DOS partition table.

Make a new partition table in the device: sudo fdisk /dev/sdb Just be patient.įor example: dd if=/dev/zero of=/dev/sdb bs=4k & syncĭd: error writing '/dev/sdb': No space left on deviceĨ127512576 bytes (8.1 GB) copied, 1236.37 s, 6.6 MB/s (option status=progress is not mandatory but provide you some feedback) Type very carefully this name or your may end up erasing one of your other disks. Replace /dev/sdb with your corresponding device. In my case its /dev/sdbĮrase everything in the pen drive (This step is Optional): sudo dd status=progress if=/dev/zero of=/dev/sdb bs=4k & sync Then identify your pen drive by it's SIZE. List your block storage devices by issuing the command lsblk In case you can't get your device formatted from the GUI, try this way.